Installing With Openserver; Installing With Solaris - Adaptec SAS/SATA/SCSI RAID Controllers Installation And User Manual

From the lower window menu, select Continue, then press Enter.
8
If the driver installation process fails, the server console is displayed so you can see the
cause of the failure.
To modify disk partitions, apply hot fixes, or perform volume maintenance, refer to your
NetWare documentation.
Continue with
9

Installing with OpenServer

Note:
You will need your OpenServer Installation CD to complete this task.
To install the driver when installing OpenServer:
Insert the OpenServer Installation CD.
1
Restart your computer.
2
Follow the on-screen instructions to begin the OpenServer installation.
3
When prompted to load more HBA drivers, insert the driver disk, then select Yes. (To load
4
more HBA drivers, repeat this step.)
When all drivers have loaded, select No.
5
Complete the OpenServer installation, following the instructions included with your
6
operating system.
Continue with
7

Installing with Solaris

Note:
You will need a floppy disk to complete this task.
To create a driver disk:
Start your computer.
1
Interrupt the autoboot, press the ESC key. The Device Configuration Assistant (DCA)
2
Utility will open.
Select F4_Add Driver.
3
Insert a floppy disk.
4
Complete the Solaris installation, following the instructions included with your operating
5
system.
Chapter 7: Installing the Driver and an Operating System
Managing Your Storage Space on page
Managing Your Storage Space on page
55.
55.
46