Installing On Windows; Installing On Red Hat Or Suse Linux; Installing On Netware - Adaptec SAS/SATA/SCSI RAID Controllers Installation And User Manual

Installing on Windows

To install the driver on Windows:
Start or restart Windows.
1
The Found New Hardware Wizard opens and searches for the driver.
Insert the driver disk, select Floppy drive, then click Next.
2
Click Next, then click Next again.
3
Follow the on-screen instructions to complete the driver installation.
4
Remove the driver disk and restart your computer.
5
Continue with
6

Installing on Red Hat or SUSE Linux

To install the module on Red Hat or SUSE Linux:
Insert and mount the RAID Installation CD:
1
Red Hat: mount /dev/cdrom /mnt/cdrom
SUSE:
mount /dev/cdrom /media/cdrom
Install the module RPM:
2
rpm -Uvh mount-point/xxx/yyy.rpm
where
mount-point
and
yyy.rpm
Reboot your computer to ensure the driver loaded correctly.
3
Run fdisk, mkfs, and create mount points for any new disk drives.
4
Continue with
5

Installing on NetWare

Note:
Before you begin, ensure that your NetWare operating system has been upgraded to the
minimum patch level specified by Novell. Refer to the Novell Web site for more information.
To install the driver on NetWare:
Start your computer.
1
At the NetWare server console prompt, type
2
loaded automatically.
At the Device types menu, select Continue, then press Enter.
3
At the Device type option, select Modify, then press Enter.
4
Select Storage Adapters, then press Enter.
5
At the Additional Driver Options menu, select Modify, then press Enter.
6
If aacraid.ham has already been detected, delete it.
7
Chapter 8: Installing the Driver on an Existing Operating System
Managing Your Storage Space on page
is the specific mount point on the Linux system,
is the rpm file.
Managing Your Storage Space on page
55.
xxx
55.
, then press Enter if it has not be
load hdetect
51
is the driver path,