Table of Contents
Advertisement
If the driver fails to load, run lsdev and check for the floppy disk drive. Then, try again with
the appropriate device.
Type
.
7
boot
Complete the FreeBSD installation, following the instructions included with your
8
operating system.
Reboot your computer, then remove the driver disk.
9
Repeat Steps
3
through
10
again for the initial bootup.
Note:
Currently, Adaptec Storage Manager is not supported on FreeBSD. To create and
ARC
manage arrays, use the
Chapter 7: Installing the Driver and an Operating System
7
the first time you boot the operating system to load the drivers
utility. See
page 57
for more information.
48
Advertisement
Table of Contents
