Installing With Unixware; Installing With Vmware; Installing With Freebsd - Adaptec SAS/SATA/SCSI RAID Controllers Installation And User Manual

Installing with UnixWare

Note:
You will need your UnixWare Installation CD to complete this task.
To install the driver when installing UnixWare:
Insert the UnixWare Installation CD.
1
Restart your computer.
2
Follow the on-screen instructions to begin the UnixWare installation.
3
When prompted to load more HBA drivers, insert the driver disk, then select Yes. (To load
4
more HBA drivers, repeat this step.)
When all drivers have loaded, select No.
5
Complete the UnixWare installation, following the instructions included with your
6
operating system.
Continue with
7

Installing with VMWare

Note:
You will need your VMWare Installation CD to complete this task.
To install the driver when installing VMWare:
Insert the VMWare Installation CD.
1
Restart your computer.
2
Follow the on-screen instructions to begin the VMWare installation.
3
Note:
The VMWare embedded driver will see the device and install.
Complete the VMWare installation, following the instructions included with your
4
operating system.
Note:
Currently, Adaptec Storage Manager is not supported on VMWare. To create and manage
arrays, use the

Installing with FreeBSD

Note:
You will need your FreeBSD Installation CD to complete this task.
To install the driver when installing FreeBSD:
Insert the FreeBSD Installation CD.
1
Restart your computer.
2
When the FreeBSD start screen opens, select 6 to escape to loader prompt.
3
Type
4
load kernel
Insert the driver floppy disk.
5
Type
6
load disk0:aacu.ko
Chapter 7: Installing the Driver and an Operating System
Managing Your Storage Space on page
ARC
utility. See page 57 for more information.
.
.
55.
47