Connecting An Interface Cable; Connecting A Utp Cable; Connecting A Fiber Optic-Cable - NEC QX-S5500G Series Installation Manual

Installation Guide
QX-S5500G Series Ethernet Switches

3.10 Connecting an interface cable

CAUTION:
After the interface cable connects to the switch, disconnect the interface cable if the port LED is green blinking.
Switch sends a great deal of broadcast packets or, there is a possibility which is being received. In this case, cut
off the network connection of equipment, and check the network and the configuration of the switch.

3.10.1 Connecting a UTP cable

To connecting an interface cable:
1) Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is
well grounded.
2) Insert a UTP cable until you hear a click.
 NOTE:
You must use Category5 cable or better (including Cat5e and Cat6).

The UTP cable is used for the connecting to 10/100/1000BASE-T autosensing Ethernet port, 1000BASE-T

SFP/SFP+ port, and management Ethernet port.

3.10.2 Connecting a fiber optic-cable

CAUTION:
Do not look in the port of each SFP/SFP+/QSFP+ transceiver module.

Please check the RX/TX position of SFP/SFP+/QSFP+ transceiver module by the direction of RX/TX which

is ▲ or ↑.
1) Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is
well grounded.
2) Do clean a LC connector with a dedicated optical connector cleaner.
3) Insert a fiber optic-cable as shown in Figure 3-37 until you hear a click.
3-31
3. Installing the switch