NEC QX-S5500G Series Installation Manual page 26

Installation Guide
QX-S5500G Series Ethernet Switches
Identify the mounting positions.
1) Wear an ESD wrist strap and make sure it makes good skin contact and is correctly
grounded.
2) Attach the front mounting brackets to the chassis:
3) Unpack the front mounting brackets and the M4 screws (supplied with the switch) for
attaching the brackets to the switch chassis.
4) Align the round holes in the wide flange of one front mounting bracket with the screw
holes in the chassis. The bracket mounting positions is Port side, power module side,
or middle installation position.
5) Use M4 screws to attach the mounting bracket to the chassis.
6) Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
Figure 3-4 Attaching the front mounting bracket to the port side
3-4
3. Installing the switch