NEC QX-S5500G Series Installation Manual page 89

Installation Guide
QX-S5500G Series Ethernet Switches
3. Set XMODEM protocol parameters
0. Return to boot menu
Enter your choice(0-3):
2) Enter 1 to set the TFTP parameters.
Load File Name
Server IP Address
Local IP Address
Subnet Mask
Gateway IP Address
Load File Name
Server IP Address
Local IP Address
Subnet Mask
Gateway IP Address
 NOTE:
To use the default setting for a field, press Enter without entering any value.

If the switch and the server are on different subnets, you must specify a gateway address for the switch.

3) Enter all required parameters, and enter Y to confirm the settings. The following
prompt appears:
Are you sure to download file to flash? Yes or No (Y/N):Y
4) Enter Y to start downloading the image file. To return to the Boot menu without
downloading the upgrade file, enter N.
Loading......................................................................
.............................................................................
.............................................................................
................................................................Done!
:update.ipe
:192.168.0.3
:192.168.0.2
:255.255.255.0
:0.0.0.0
Table 6-6 TFTP parameter description
Item
Name of the file to download (for example, update.ipe).
IP address of the TFTP server (for example, 192.168.0.3).
IP address of the switch (for example, 192.168.0.2).
Subnet mask of the switch (for example, 255.255.255.0).
IP address of the gateway (in this example, no gateway is required
because the server and the switch are on the same subnet).
Description
6-18
6. Upgrading software