Cleaning And Maintenance - Krups Pump espresso Manual

„ To make a cappuccino, fill a container with approximately 60 to 100 ml of milk. For best
results, use a narrow and relatively small container that can be slipped under the steam
nozzle (G) (40). For best results, the milk and container should be very cold.
„ Place the nozzle into the container of milk and turn the thumb wheel to the right, to the
steam position.
„ For best results, foam the milk near the bottom of the container for approximately 10
seconds, taking care not to touch the bottom. Then slowly tilt the container and move the
nozzle upwards until it is almost at the surface of the milk. Make sure that the nozzle does
not leave the milk. To get a great foam, move the container in circular motions.
„ To get the best foam, we recommend using pasteurised or UHT milk, and to avoid using
non-pasteurised or skimmed milk.
„ Once you have achieved the best foam, turn the thumb wheel to position O (41)
„ To prevent overheating the milk, do not use the steamer for more than 45 seconds (for
100 ml of milk).
„ You can start making an espresso by following the steps detailed above.
„ To prevent milk from drying inside the nozzle, please clean it after each use. To do this,
follow the steps for foaming the milk, replacing 100 ml of milk with 60 ml of water. To avoid
burning yourself, remove the nozzle from the foam (G.1) and wash it in clean water (42).
Clean the steam nozzle using a damp cloth (G) (43).
„ Remove the drip tray, empty it and clean it using clean water (44-45).
„ Refer to the next section for manual cleaning.
IMPORTANT!
Warning! To prevent the milk from spattering, do not lift the nozzle out of
the milk when using "steam" mode.
IMPORTANT!
Warning! The steam nozzle is still hot! Be careful you do not burn yourself!
IMPORTANT! After switching off the steam function, clean the nozzle
immediately and carefully, as set out in the section: CLEANING AND
MAINTENANCE
1. The appliance
„ Unplug (J) before each clean and let the appliance cool down first.
„ Clean the outside of the appliance with a damp sponge when you think it necessary.
Regularly clean the tank, drip tray and its grill then wipe them down.
„ Rinse the inside of the tank regularly.
„ When a fine white layer appears in the tank, descale the appliance (refer to the section
on descaling)
„ Do not use alcohol or solvent-based cleaning products.
„ After unplugging the appliance, regularly clean the head of the filter holder and the seal
(E) using a damp sponge.
„ Clean with a damp cloth only. Do not use detergent or abrasive products.

CLEANING AND MAINTENANCE

7