Cleaning And Maintenance - Krups XP320850 Manual

IMPORTANT! If you want to make a coffee after frothing milk, you shoud turn
the thumb wheel to the espresso position
to the espresso position. After few seconds, the coffee indicator will turn off.
Turn the thumb wheel to function O and wait until the coffee indicator lights up.
During this operation, if the coffee and steam indicator lights are switched on at
the same time, repeat the steps above.
IMPORTANT!
Warning! To prevent the milk from spattering, do not lift the nozzle out of the
milk when using "steam" mode.
IMPORTANT!
Warning! The steam nozzle is still hot! Be careful you do not burn yourself!
IMPORTANT! After switching off the steam function, clean the nozzle
immediately and carefully, as set out in the section: CLEANING AND
MAINTENANCE
1. The appliance
„ Unplug (J) before each clean and let the appliance cool down first.
„ Clean the outside of the appliance with a damp sponge when you think it necessary.
Regularly clean the tank, drip tray and its grill then wipe them down.
„ Rinse the inside of the tank regularly.
„ When a fine white layer appears in the tank, descale the appliance (refer to the section
on descaling)
„ Do not use alcohol or solvent-based cleaning products.
„ After unplugging the appliance, regularly clean the head of the filter holder and the seal
(E) using a damp sponge.
„ Clean with a damp cloth only. Do not use detergent or abrasive products.
2. The filter holder
„ Using a damp cloth, regularly clean the filter holder housing in order to remove any
residual coffee that may have collected in this area.
„ Do not remove the seal. Do not remove the screws from the filter and filter holder.
This may only be carried out by an approved servicing centre.
„ To prolong the life of the filtering head seal, do not refit the filter holder if the coffee
machine will not be used for an extended period of time.
3. The drip tray
„ If necessary, clean the drip tray (I) and its grill (H) using water and a little mild detergent
(44-45). Rinse and dry.
8

CLEANING AND MAINTENANCE

and then set the selection button