Table of Contents
Advertisement
Available languages
Available languages
PROBLEMS
The espresso leaks out the
sides of the filter holder.
Your espresso tastes bad.
The appliance does not
work.
The nozzle does not work
or produces little foam.
If it is not possible to determine the cause of the fault, consult an approved retailer. Never
disassemble the appliance! (if the appliance is disassembled, this will void the guarantee).
ELECTRICAL OR ELECTRONIC PRODUCT END OF LIFE
Help protect the environment!
Your product contains a number of recoverable or recyclable materials.
Take these to a collection centre, or to an approved service centre for
processing.
POSSIBLE CAUSES
The filter holder is not
positioned correctly.
The edge of the filter holder
is clogged by the coffee.
After descaling, the rinsing
cycle was not carried out
correctly.
The pump is disabled due
to a lack of water.
The removable water tank
is incorrectly positioned.
The appliance is not
connected.
The foam nozzle is not
correctly installed.
The milk is too hot.
SOLUTIONS
Fit the filter holder in
position and lock it (turn
from left to right until it
stops).
Remove any excess coffee
that prevents you from fully
locking the filter holder.
Remove the excess coffee
and clean the grill through
which the water flows using
a damp sponge.
Rinse the appliance in line
with the user instructions
and check the quality of the
coffee.
Fill the water tank and
restart the pump (refer to
the section: FIRST USE).
Avoid emptying the tank
completely.
Position the water tank
correctly.
Ensure that the appliance is
switched on.
Check that the accessory
is correctly mounted on
the appliance: remove then
re-install it on the hinged
arm using a firm upward
movement.
Use fresh, pasteurised or
UHT milk that has been
recently opened.
11
Advertisement
Table of Contents
