Directed Diagnostics - Alcatel MainStreet 2902 Manual

26 — System diagnostics
Procedure 26-2 To set background diagnostics on a specific circuit
where
pp is 1 or 9, and c is 1, 2, A or B
p is 1 or 2, and c is 1 to 31
* Default
26.3

Directed diagnostics

Directed diagnostics run a specific test on a specific circuit. After the test has run, the
system resumes background diagnostics, if enabled. Directed diagnostics do not run
on circuits that have had diagnostics disabled.
You can select a diagnostic test to run:
•
once (X1)
•
10 times (X10)
•
100 times (X100)
•
continuously (or locked) (LOCK)
Directed diagnostics are supported for primary rate and interface module circuits.
If the specified circuit is busy, the display shows the message "Device momentarily
unavailable for testing" until the circuit is ready to be tested, at which time the
directed test is carried out.
Procedure 26-3 To set directed diagnostics on a circuit
where
pp is 1 or 9, and c is 1, 2, A or B
p is 1 or 2, and c is 1 to 31
* Default
26-4
CONFIG — CIRCUIT — <pp-c> or <Pp-c> ↵ — MORE
CONFIG — CIRCUIT — <pp-c> or <Pp-c> ↵ — MORE
ENAB_DIAG/DISAB_DIAG*
ENAB_DIAG/DISAB_DIAG*
2902 MainStreet Technical Practices
90-2906-01
SK000536
SK000536
May 2002