Table of Contents
Advertisement
18.3
Device mode
The RS-232 DCM supports two device modes:
•
synchronous
•
asynchronous
When you configure a circuit as synchronous, clocking parameters must be set
(see section 18.9). When configured as asynchronous, the data structure must be set
(see section 18.8).
For more information on device mode, see section 17.3.
Procedure 18-2 To set the device mode
where pp is 1 or 9, and c is 1 or 2
* Default
18.4
Device gender
The RS-232 DCM supports two device genders:
•
DTE
•
DCE
For more information on device gender, see section 17.4.
2902 MainStreet Technical Practices
May 2002
90-2906-01
If asynchronous mode is selected, transparent rate adaption
Note —
cannot be used.
CONFIG — CIRCUIT — <pp-c> ↵ — FUNCTION — I/F_MODE
18 — RS-232 DCM
SYNC*/ASYNC
SK000495
18-3
Advertisement
Table of Contents
