Troubleshooting; Error, Cause And Remedy - Trotec Speedy 360 flexx Operating Manual

Troubleshooting

9 Troubleshooting
This chapter should enable the maintenance personnel to identify and resolve operational faults based on
error messages and symptoms.
Warning
Risk of fire from incorrect parameter settings.
Laser operation with incorrect parameter settings such as power settings, speed or frequency
can result in flame formation.
– Laser operation permitted only under supervision.
Caution
System failures that cannot be remedied can cause damage to the machine.
– Disconnect the machine from the mains and contact your local Technical Support.
9.1

Error, cause and remedy

Problem
Too low engraving depth.
Blurred edges.
Missing cut lines.
Waviness of the lines.
No visible marking result.
86
Possible cause
Imprecise focusing.
•
Dirty optics.
•
Imprecise focusing.
•
Zero passes in material
•
database.
Line thickness in CorelDraw
•
too big.
Color was skipped in
•
JobControl®.
Lens is loose.
•
Too low laser power.
•
Too high speed.
•
Not focused.
•
Wrong focus tool.
•
Remedy
Check focus.
•
Clean optics.
•
Check focus.
•
Increase the amount of passes
•
in the JobControl® material
database.
Reduce line thickness to the
•
smallest possible value.
Set color to cutting in the
•
JobControl® database.
Check lens and lens holder.
•
Increase power setting.
•
Reduce speed.
•
Check focus.
•
Change focus tool.
•
When using autofocus, check
•
the settings within the software
(lens, material thickness,
table).