Unpacking The Machine - Trotec Speedy 360 flexx Operating Manual

5.7

Unpacking the machine

Only trained and authorized personnel are permitted to transport and unpack the machine. To avoid falling off
of any wooden parts or tipping of the machine, be very careful when opening the transport case.
Notice
Keep the original packaging case, in case of machine needs to be transported or relocate.
Dispose all waste according to the applicable waste disposal law.
Caution
The lens unit should be unpacked only after installation of the machine. The lenses are high-
quality optical components which must be kept clean in order to ensure optimum marking
results. Never touch the lenses with bare fingers.
Steps:
1. Position the transport case vertically on level ground (using a pallet truck or forklift).
2. Remove any vertical tightening straps.
3. First remove the top and afterwards the side plates of the transport case.
4. Slide out the two wooden rails in the form of ramps that are stored beneath the machine.
5. To secure the machine against moving, the wheels are locked using wooden blocks.
In order to remove those blocks, put the two wooden rails together, push the upper part of the rails under
one side of the machine and press down the rail in order to reach a levering effect.
6. Pull out the blocks.
7. Repeat this procedure on the opposite side as well.
8. Now you can pull out the blocks.
Transport
51