Adjusting The X-Y Parts - SunStar SPS/E-1306 Series User Manual

6.10) Adjusting the X-Y Parts

6.10.1) Adjusting the tension of the X-timing Belt
1) Move the race table to the left.
2) Use the tension gauge to adjust the X-tension adjustment bolt so that 800g of load is applied 4mm longer on
the timing belt. Tighten the nut after the tension is adjusted.
If the timing belt is too tense, the belt may be damaged, and if the belt is too relax, the transfer in
direction X may become difficult.
Caution
3) Tighten the X-bracket screw.
Belt Tension Gauge
Tightening
Screw
6.10.2) Adjusting the tension of the Y-timing Belt
Use the tension gauge to adjust the Y-tension adjustment bolt so that 1100g of load is applied 3mm away from the
center of the timing belt. Then, tighten the Y-bracket screw.
If the timing belt is too tense, the belt may be damaged, and if it is too relax, the transfer in direction Y
may become difficult.
Caution
Adjusting Bolt
32
Race Table
X-Timing Belt
Nut
Adjusting
Bolt
Tightening
Screw
Belt Tension
Gauge
Y-Timing Belt
800g
4mm
3mm
1100g
Belt Tension Gauge
X-Timing Belt
Y-Timing Belt
Belt Tension Gauge