Honeywell 2MLF-AV8A User Manual page 105

Error Code
(Decimal)
41#
42#
43#
50#
60#
70#
80#
At error code, # indicates channel where error occurs.
REFERENCE - INTERNAL
For more details on error code, refer to section Error Codes.
3. In case, two error code occurs, module saves first occurred error code and later
occurred error code is not saved
4. In case error occurs, after modifying error, use error clear request flag, restart power
to delete error code and stop LED flicker. For more details about error clear request
flag, refer to
R200 Analog Input Module 2MLF-AV8A, AC8A User's Guide
September 2010
5. Configuration and Function of Internal Memory
5.5. PUT/GET function block use area (parameter area)
Error Contents
Offset value of 0~5V (0~20mA)
range is set as larger or equal than
gain value
Offset value of 0~10V range is set
as larger or equal than gain value
Offset value of -10~10V range is
set as larger or equal than gain
value
Filter constant setting range
exceeded
Time average setting range
exceeded
Count average setting range
exceeded
Analog input range setting error
Error Clear request Flag (%UXa.b.176, a: Base No, b: Slot No.).
Honeywell
Remark
RUN LED flickers every
1s
Applied at 2MLF-AC8A
105