Honeywell 2MLF-AV8A User Manual page 103

2.
3.
4.
B15 B14 B13 B12
- - - -
At device allocation, 'a' means base number, 'b' means slot number, where module is installed.
R200
September 2010
In case of setting value other than setting range:
If time average setting range exceeds, then error number 60x shows up.
−
If count average setting range exceeds, then error number 70x shows up. At this
−
time, initial value is applied and calculated.
If the Time/Count average process value is not set, initial value is applied and
calculated (Time average: 4, Count average: 2).
The following figure is an example for setting count average as 30 at channel 1.
B11 B10 B9
- - -
Address
_Fab_CH0_AVG_VAL
_Fab_CH1_AVG_VAL
_Fab_CH2_AVG_VAL
_Fab_CH3_AVG_VAL
_Fab_CH4_AVG_VAL
_Fab_CH5_AVG_VAL
_Fab_CH6_AVG_VAL
_Fab_CH7_AVG_VAL
_Fab_CH0_AVG_
Analog Input Module 2MLF-AV8A, AC8A User's Guide
5. Configuration and Function of Internal Memory
5.5. PUT/GET function block use area (parameter area)
B8 B7 B6 B5
- CH# filter constant
Description
CH0 average process value setting
CH1 average process value setting
CH2 average process value setting
CH3 average process value setting
CH4 average process value setting
CH5 average process value setting
CH6 average process value setting
CH7 average process value setting
VAL CH0 average process value setting
Honeywell
B4 B3 B2 B1
103
B0