Preparation; Terminal Designation; Table 6-1 Terminal Designations Using The 1U1-1 As An Example; Figure 6-1 Water Drip Loop - Siemens SIMOTICS T-1FW4407-1KM81-1BC0-Z Operating Instructions Manual

Electrical connection

6.3 Preparation

● Connect the machine in such a way that a permanent, safe electrical connection is
● Lay and secure external auxiliary cables separately from the main cable. Elements with
● In case of high humidity or when installed outside, water drops can move along the cable
6.3 Preparation
6.3.1

Terminal designation

According to IEC / EN 60034‑8, the following basic definitions apply to the terminal
designations for 3-phase machines:
Table 6-1
1
x
52
maintained. Avoid protruding wire ends.
cable ties may be present for this purpose.
jacket and enter the motor through the cable entry and cable gland.
If you route the cable with an appropriate loop then water doesn't enter the terminal box,
but simply drips off.
Figure 6-1 Water drip loop
Terminal designations using the 1U1-1 as an example
U 1 - 1 Designation
Index for pole assignment for pole-changing machines where applicable. A lower
index signifies a lower speed. Special case for split winding.
x Phase designation U, V, W
x Index for winding start (1) or end (2) or if there is more than one connection per
winding
x Additional indices for cases in which it is obligatory to connect parallel power feed
cables to several terminals with otherwise identical designations
SIMOTICS T-1FW4 Heavy Duty 1FW4407-1KM81-1BC0-Z
Operating Instructions 11/2018