Table of Contents
Advertisement
Maintenance
9.3 Preparation and notes
Dust disturbances when working with compressed air
When cleaning with compressed air, dust, metal chips, or cleaning agents can be whirled up.
Injuries can result.
When cleaning using compressed air, make sure you use suitable extraction equipment and
wear protective equipment (safety goggles, protective suit, etc.).
NOTICE
Damage to insulation
If metal swarf enters the winding head when cleaning with compressed air, this can damage
the insulation. Clearance and creepage distances can be undershot. This may cause damage to
the machine extending to total failure.
When cleaning with compressed air, ensure there is adequate extraction.
NOTICE
Machine damage caused by foreign bodies
Foreign bodies such as dirt, tools or loose components, such as screws etc., can be left by
accident inside the machine after maintenance is performed. These can cause short circuits,
reduce the performance of the cooling system or increase noise in operation. They can also
damage the machine.
• When carrying out maintenance work, make sure that no foreign bodies are left in or on the
• Securely attach all loose parts again once you have completed the maintenance procedures.
• Carefully remove any dirt.
Note
Operating conditions and characteristics can vary widely. For this reason, only general intervals
for inspection and maintenance measures can be specified here.
9.3
Preparation and notes
If the paint is damaged, it must be repaired in order to protect the unit against corrosion.
Note
Paint system
Contact the Service Center (Page 117) before you repair any damage to paint. They will provide
you with more information about the correct paint system and methods of repairing paint
damage.
88
CAUTION
machine.
1PC1423 roller-table motors SH 112 ... 400
Operating Instructions
Advertisement
Table of Contents
