Maintenance; General; Preparation And Notes; Marking - Siemens SIMOTICS SD Operating Instructions Manual

Maintenance

9.1

General

Through careful and regular maintenance, inspections and overhauls, you can detect faults at
an early stage and resolve them. This means that you can avoid consequential damage.
Operating situations and characteristics can vary widely. For this reason, only general
maintenance intervals can be specified here. Maintenance intervals should therefore be
scheduled to suit the local conditions (dirt, starting frequency, load, etc.).
Comply with the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 19).
• Comply with the applicable national and sector-specific regulations.
• When using the motor within the European Union, comply with the specifications laid down
in EN 50110‑1 regarding safe operation of electrical equipment.
Note
Please contact the service center, if you require support with service, maintenance or repair.
9.2

Preparation and notes

9.2.1

Marking

When making changes or repairs, maintain the corresponding design standards! These
machines are labeled on the rating plate with the following markings.
1LE5, 1PC4 shaft heights 280 ... 355
Operating Instructions, 11/2022, A5E41454666A
UKCA marking
Great Britain (England, Wales and Scotland)
Underwriters Laboratories
Canadian Standard Association
Canadian Standard Association Energy Efficiency Verification
9
97