Advertisement
Hardware Changes
CPU Torque Tool
Beginning in June 2004, CPU torque tools are not shipped in the Sun Blade 2000
workstation. The torque tools are shipped with the CPU modules.
CPU Module Options
You should verify which CPU modules are installed in your workstation before you
purchase or install new CPU modules. There are two types of UltraSPARC III CPU
modules: Cu, or copper process CPU modules, and non-Cu modules.
Caution – Never mix UltraSPARC III 600, 750, or 900 MHz (Non-Cu) CPU modules
with UltraSPARC III Cu CPU modules. The workstation will not boot if the modules
are mixed.
Identifying a CPU Module
There are three ways to identify a CPU module:
Software method: Type the correct prtdiag command in a terminal window.
Inspect the CPU module for an UltraSPARC III Cu label.
Check the part number label. (This method requires you to remove the module
from the workstation and is not recommended unless absolutely necessary.)
Software Method
In a terminal window, type one of these commands:
/usr/platform/SUNW,Sun-Blade-1000/sbin/prtdiag
/usr/platform/SUNW,Sun-Blade-2000/sbin/prtdiag
The system displays CPU information similar to
CODE EXAMPLE 1
Sun Blade 1000 and Sun Blade 2000 Product Notes
.
11
Advertisement
