Configure Horn Submenu; Configure Strobe Submenu - Macurco DVP-120C User Instructions

Macurco DVP-120C Manual
The default turn-on delay is one minute, and the maximum allowed value is fifteen minutes. The value is entered in
two groups, 2 digits for the minutes and then 2 digits for the seconds. A leading zero must be entered for each group
if applicable.
4.13.4.4 Relay Minimum on Time
The default minimum on time is one minute and the maximum allowed value is fifteen minutes.

4.13.5 Configure Horn Submenu

The configuration parameters for the horn are similar to those for relays. A horn would not normally require a
minimum on time, but this parameter allows a more versatile configuration.
4.13.5.1 Horn Summary
This display example shows that the horn has been configured to operate with a turn on delay and no minimum on
time.
Notice that the horn number, 4, is underlined. This indicates that the digit keys can be used to jump to a particular
relay, horn or strobe. The relays are numbers 1, 2 and 3; the horn is number 4 and the strobe is 5.
4.13.5.2 Horn Turn on Delay
The default turn-on delay is one minute, and the maximum allowed value is fifteen minutes.
4.13.5.3 Horn Minimum on Time
The default minimum on time is zero and the maximum allowed value is fifteen minutes.

4.13.6 Configure Strobe Submenu

The configuration parameters for the strobe are the same as those for relays. A strobe would not normally require a
minimum on time, but this parameter allows a more versatile configuration.
4.13.6.1 Strobe Summary
REV – 1.0
Figure 4-60 Delay time
R e l a y 1
( m m : s s )
Figure 4-61 Minimum on time
H o r n 4
D e l a y O n
Figure 4-62 Horn Summary
H o r n D e l a y
( m m : s s )
Figure 4-63 Horn Turn on Delay
H o r n
( m m : s s )
Figure 4-64 Horn Minimum on Time
S t r o b e 5
[34-8708-4770-8 ]
M i n . O n
0 1 : 0 0
O n
0 1 : 0 0
M i n . O n
0 0 : 0 0
43 | P a g e