Tiger 6020009 Mounting And Operating Instructions page 84

DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours
of service, following the detailed maintenance instructions in the
operators manual.
______ Pump Drive Shaft: If required with drive shaft / coupler check for
end play and lubricate at zerks.
______ Crankshaft adapter: If equipped with rubber grommets check
______ Pivot points: Inject grease until it appears at ends.
______ Hydraulic fittings: Check for leaks with paper or cardboard. Tighten
______ Knives: Inspect for missing or damaged knives, change (only
______ Belts: Check / Tighten / Replace belts as needed.
______ Main Frame / Deck: Unless otherwise specified retorque bolts
______ Hydraulic Fluid Level: Add, if required, per fluid recommendations.
______ Rear Flail Drive, Bearing
Flange and Shaft Couplers: Grease as instructed in the detailed
(if applicable)
______ Cutter Shaft and Ground Roller: Grease as instructed in the detailed
Service performed by:_______ Date:____/____/____ Hour
Meter:__________
** This page may be copied and used as part of the daily maintenance routine.
MAINTENANCE
condition, replace if missing or damaged.
fittings or replace hoses immediately.
complete sets) as needed.
according to torque specifications in this
section.
Maintenance Section
Twin Rtry Maintenance Section 4-22
maintenance section.
maintenance section