Bearing Adjustment - Tiger 6020009 Mounting And Operating Instructions

MAINTENANCE

BEARING ADJUSTMENT

1 – Clamp the bottom end of the spindle securely in a vise so the spindle housing
turns freely.
2 – Position a magnetic base dial indicator on the stationary cylinder of the spindle
housing. Locate the end of the dial indicator against the flat end of the spindle shaft.
The dial indicator will now measure accurately bearing end play.
3 – Tighten the bearing adjustment nut until there is .012 inch movement when the
spindle housing is pried upward away from the vise jaws.
4 – When there is .012 inch free play between the spindle and housing, install the
bearing lock nut (thick nut). Hold the adjusting nut securely and tighten the lock nut
to 300 ft. lbs. of torque.
5 – After the lock nut is tightened, there must be .001 inch to .003 inch of free play
when lightly prying up on the spindle housing.
If the end play is correct, .001 inch to .003 inch, bend tabs up on jam washer to
prevent the lock nut from loosening.
If the end play in NOT correct, loosen the lock nut and turn the adjustment nut as
required and re-tighten the lock nut. Repeat first part of step 5.
Twin Rtry Maintenance Section 4-21