Tiger 6020009 Mounting And Operating Instructions page 45

Check that all grease zerks have been installed in the draft beams pivot arm, left
linkage arm, right linkage arm, and cylinder mounting ears.
Using a clevis pin and roll pins, connect the pivot arm to clevis on draft beam.
NOTE: Make sure the longer distance between the cutout and the end of the pivot
arm is closest to the draft beam pivot ears on the center tube as shown in the
diagram below. Also make sure the cutout on the pivot arm faces into tube of draft
beam.
Slide other end of pivot arm with short distance between the cut-out and the end
of the pivot arm, into the cylinder clevis. Next, line up the holes of the left and right lift
linkage arms outside of the cylinder clevis holes. Connect with linkage pin, shims
(as required), boss, cap-screw, lock-washer and hex nut as shown.
To connect the bonnet to the draft beam, slide the extension arms of the draft
beam between the mounting ears on the inner end of the bonnet. Line up the holes
and secure with swivel pin, cap-screw, lock-washer, and hex nut (both sides). See
parts book illustration.
Next, slide the left and right linkage arms up to the slotted ear on the side of the
deck. Secure with linkage pin, shims, boss, cap-screw, lock-washer and hex nut.
See illustration in parts section.
DECK / MOTOR FEEDLINE
Install the 1" hose with the 180 degree flange on the front side of the motor to the
top of the solenoid valve. Secure to motor with flange kit, and install swivel fittings on
the other end. Install the other 1" hose with the 60 degree flange on the back side of
the motor to the bottom of the solenoid valve.
Install split hoses around hydraulic hoses where they contact sharp edges, or any
other edges that may rub hoses.
ASSEMBLY
DECK MOUNTING
Assembly Section 2-19