Tiger 6020009 Mounting And Operating Instructions page 40

CABLE LIFT DRAFT BEAM INSTALLATION
Install ½" O-ring breather into butt port of inboard cylinder. In all fittings in the
rod end of the cylinder according to diagrams in parts section. These fittings
should be positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the
shoulder and lock into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the pin,
flat-washers and R-clips as shown below.
ASSEMBLY
Assembly Section 2-14