Tiger 6020009 Mounting And Operating Instructions page 34

NOTE: This should be done after mounting the main frame.
1. Cut the tractor hood as shown in pic. # 1 to accomodate modified exhaust turbo
tube.
2 Remove the muffler from existing turbo tube.
3. Remove existing turbo tube from tractor turbo.
4. Install the exhaust mounting bracket and supporting brace.
5. Cut the existing tube at turbo end 4-3/8" from hole center as shown in pic. # 2
and 3. Discard remaining portion of existing tube.
6. Install the turbo end of existing tube to the tractor turbo.
7. Install the supplied tube to the turbo end of existing tube with exsting hardware
as shown in pic. # 4. Do not tighten the hardware.
8. Install the exhaust clamp to the exhaust mounting bracket with the supplied
hardware. Refer parts section for the details.
9. Tighten the turbo existing hardware.
10. Cut the muffler 8" off at the top as shown in pic. # 5 and weld the sweep back
on to the top of the muffler maintaining the same direction. Then install muffler
to the turbo tube with the existing hardware.
Picture # 2
ASSEMBLY
EXHAUST MOUNT
Assembly Section 2-8
Picture # 1
Picture # 3