Tiger 6020009 Mounting And Operating Instructions page 44

COMBO LIFT DRAFT BEAM INSTALLATION
Install ½" O-ring breather into butt port of inboard cylinder. In all fittings in the rod
end of the cylinder according to diagrams in parts section. These fittings should be
positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder
and lock into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the pin,
flat-washers and R-clips as shown below. Use teflon tape on all fitting and hose
connections.
Install all fittings in the outboard cylinder and adjust to point towards the butt end
of the cylinder. Attach the hoses as specified in the parts book. Slide the cylinder
into the draft beam from the outside of the draft beam and attach cylinder to the draft
beam with clevis pin and R-clips.
Pull the inboard cylinder piston rod down to the extreme extended position. Slide
the draft beam under the cylinder, and align clevis hole with draft beam hole nearest
to the tractor. Install pin and secure with R-clips.
Using inboard cylinder as a pivot point, slide draft beam under tractor and install
draft beam pin. Align hole in draft beam pin with holes in main frame boss and install
cap-screw, lock-washer and hex nut.
ASSEMBLY
DRAFT BEAM MOUNTING
Assembly Section 2-18