Tiger FLX10 Operator's Manual page 73

If you hit a solid object or foreign debris, stop the flex arm,mower, and tractor at once. Immediately idle the engine
speed and disengage the PTO. Wait for all mower rotating motion to stop, then raise the mower and move the
tractor and implements off the object. Inspect the area and remove, or mark the location of the debris. Inspect the
condition of the mower and make any needed repairs immediately. Make sure the blades are not damaged and
the carrier is balanced before resuming operation.
Always wear your seat belt securely fastened and only operate the tractor, flex arm and mower with the ROPS in
the raised position. If the tractor, flex arm, or mower hits a tree stump, rock, or bump, a sudden movement could
throw you off of the seat and under the tractor,flex arm, and mower The seat belt is your best protection from
falling off the tractor and the ROPS provides protection from being crushed during a tractor roll-over.
10.2 Bystander/Passersby Precautions
If a bystander comes within 100 yards of the tractor while the mower is being operated, stop the tractor at once,
idle the engine and disengage the PTO. Do not engage the PTO again until all bystanders are well past the 100
yard distance.
DANGER!
Rotary Mowers are capable under adverse conditions of throwing
objects for great distances (100 yards or more) and causing
serious injury or death. Follow safety messages carefully.
STOP MOWING IF PASSERSBY ARE WITHIN 100 YARDS UNLESS:
-Front and Rear Deflectors, Chain Guards, or Bands are installed and in good, workable condition;
-Mower sections or Wings are running close to and parallel to the ground without exposed Blades;
-Passersby are outside the existing thrown-object zone;
-All areas have been thoroughly inspected and all foreign material such as rocks, cans, glass, and general
debris has been removed.
NOTE: Where there are grass and weeds high enough to hide debris that could be struck by the blades,
the area should be: inspected and large debris removed, mowed at an intermediate height, inspected
closely with any remaining debris being removed, and mowed again at the desired final height. (This will
also reduce power required to mow, reduce wear and tear on the Mower drivetrain, spread cut material
better, eliminate streaking, and make the final cut more uniform.)
FLX15/10 04/06
© 2006 Alamo Group Inc.
OPERATION
Operation Section 4-29
(SRM-1)