Tiger FLX10 Operator's Manual page 36

1. From Shipping Position (FLX15/10)
The Flex arms will be shipped almost completely as-
sembled. Remove the flex arm from the trailer using an
overhead boom. Attach chains to the flex arm using the
three lifing hooks in the locations shown. The lengths
of the chains may need to be adjusted to provide a level
lift of the flex arm.
Use the following procedure to get your implement
field ready.
Block the flex arm under the frame at point "A".
Remove the four shipping brackets, "B"and discard.
Break the bands securing the arm strut "C" and the
*
castor link "D".
Swing the hitch forward and connect the arm strut to
hitch at point "E". Use the 1/2" bolt, lock washer, and
flat washer to tighten the pin.
Connect the castor link to the castor arm at point "F"
using the provided pin and hardware.
upwards.
Connect to the tractor drawbar and remove the blocking.
Drive the flex arm ahead to straighten the left wheel
*
standard.
Connect the other end of the castor link to the arm
frame "G" using the provided pin and hardware.
*
Does not apply to the FLX10.
FLX15/10 04/06
© 2006 Alamo Group Inc.
ASSEMBLY
*
Face the pinhead
*
Assembly Section 3-2