Table of Contents
Advertisement
Troubleshooting
* CAUTION! *
NO PAPER ()
* CAUTION! *
SEPARATOR JAM
* CAUTION! *
FUSER JAM
* CAUTION! *
PAPER MISFEED
PAPER SIZE ERROR
* CAUTION! *
TONER EMPTY
* CAUTION! *
ADF COVER OPEN
SERVICE CALL
(CXXXX)
* REDIAL ALL FAILED *
* COMM.ERROR *
* NOT REGISTERED! *
12 - 2
Machine is out of paper
(There is A4 size in tray 1)
Paper is jammed inside the
machine
Paper jam near FUSER
Paper pick up mis-feed
The paper installed is not
correct size.
Machine is out of Toner
The cover of the ADF is
open
A hardware related error
occurred.
The document is not
transmitted to the other
party even with repeated
auto redial.
An error has occurred and
communication was
unsuccessful.
There is no destination
information registered in
the One Touch key or
Speed Dial you have just
pressed.
Replenish paper.
Remove jammrd paper.
Open and close main unit
cover.
Remove jammed paper.
Open and close main unit
cover
Remove jammed papers if
necessary.
Open and close main unit
cover.
Be sure you have installed
the correct paper size, then
press any key to release the
ERROR state, and then
press "Start" key to resume
machine operation. After
warming up, the machine
prints the last copy again.
Or, change the paper size
setting.
Add new Toner.
Close the cover of the ADF.
Try turning the power OFF
then ON.
If this error is displayed
again, contact your service
representative.
Press the Stop key, then try
another transmission
sequence.
At transmission
Press the Stop key, and
then the Yes key. Then try
another transmission
sequence.
At reception
Ask the other party to try
another transmission.
Select the One Touch key or
Speed Dial, which contains
the information of the
destination you are trying to
send.
Or register a new One
Touch Dial or Speed Dial.
Service and Supplies
Advertisement
Table of Contents
