Ej Roller Unit Removal - Epson Stylus PHOTO 950 Service Manual

EPSON Stylus PHOTO 950

4.2.9 EJ Roller Unit Removal

1. Remove the Front Paper Guide. (Refer to Section 4.2.8.)
2. Remove the grounding wire that are connecting the EJ roller shaft and the printer
mechanism.
Figure 4-52. EJ Grounding Wire Removal
3. Remove the two bushings from the mounting holes, and turn the unit upward.
Bush
Figure 4-53. Bushing Removal
DISASSEMBLY AND ASSEMBLY
EJ Grounding Wire
EJ Roller Unit
Bush
Disassembly
4. Lift up the EJ Roller Unit to remove it.
When installing the EJ roller shaft, the end with the carriage
C A U T I O N C A U T I O N C A U T I O N
lock lever attached should be on the right side when the EJ roller
shaft is installed to the printer mechanism.
The carriage lock lever should be installed as shown in Figure
4-54, with point A at the bottom and positioned forward of the
projection on the frame.
CR Lock Lever
Figure 4-54. Carriage Lock Lever Installation Direction
Revision A
Point A
118