Head Cleaning Operation - Epson Stylus PHOTO 950 Service Manual

EPSON Stylus PHOTO 950
16. Accede to following steps to check right side PG again.
START
Move the CR unit using
timing belt.
Thickness Gauge
moves?
No
One notch up the Parallel
adjust bushing.
Move the CR unit using
timing belt.
Thickness Gauge
moves?
No
Re-adjust from
the beginning.
Figure 5-41. Right / Left Sides PG Checking
17. Tighten both screws completely.
ADJUSTMENT
Yes
Re-adjust from
the beginning.
NOTE: "up" means PG (Platen Gap) narrow.
NOTE: "down" means PG (Platen Gap) wide.
Yes
One notch down the
Parallel adjust bushing.
Advance to Step 17.

5.2.10 Head Cleaning Operation

This section describes how to perform the cleaning that Stylus PHOTO 950 supports.
The cleaning that the adjustment program supports is the powerful cleaning called
CL3, and you can try recovering the clogged nozzle(s) efficiently.
NOTE: If you cannot recover clogged nozzle(s), advance to "Section 5.2.4" for
the "ink charge" operation.
1. Setup the adjustment program. Main screen (Figure 5-3) appears.
(Refer to Section 5.2.1.)
2. Select "Maintenance" and then "Head cleaning".
3. Main screen changes as below.
Figure 5-42. Head Cleaning Initial Screen
Adjustment
Revision A
154