Epson Stylus PHOTO 950 Service Manual page 98

EPSON Stylus PHOTO 950
5. Peel the double-sided tape off the panel circuit board that is secured to the
underside of the upper housing, and then disconnect the FFC.
FFC
Figure 4-5. FFC Removal
When connecting the FFC to the panel circuit board, be sure to
C A U T I O N C A U T I O N C A U T I O N
affix the double-sided tape that is attached to the FFC to the upper
housing.
DISASSEMBLY AND ASSEMBLY
Panel Board
Disassembly
4.2.1.2 Rear Housing Removal
1. Remove the Upper Housing. (Refer to Section 4.2.1.1.)
2. Remove the four screws 3) C.B.S 3x8 and the two screws 4) C.B.P 3x10 that are
securing the Rear Housing.
Rear Housing
[Left-rear side]
4) C.B.P 3x10
Figure 4-6. Screws Securing the Rear Housing
3. While pushing the left and right sides of the rear housing inward one by one,
remove the rear housing.
Figure 4-7. Rear Housing Removal
Revision A
[Right-rear side]
4) C.B.P 3x10
3) C.B.S 3x8
Hokks
98