Paper Load Roller Unit Removal - Epson Stylus COLOR 1520 Service Manual

EPSON Stylus COLOR 1520

3.2.10.11 Paper Load Roller Unit Removal

1. Remove the printer mechanism unit. (Refer to Section 3.2.6.)
2. Remove the paper eject frame. (Refer to Section 3.2.10.7.)
3. Remove the CR unit. (Refer to Section 3.2.10.9.)
4. Remove the base frame assembly. (Refer to Section 3.2.10.10.)
5. Attach the knob to the PF roller shaft, and press the trigger lever down. Then rotate the paper load
roller unit by turning the knob clock wise to hold the edge guide unit down.
6. Remove 1 screw (CBP, 3X8) securing the paper eject drive unit to the left frame assembly, and
remove the paper eject drive unit by lifting up the front edge.
PF Roller Unit
Screw (CBP 3X8)
Left Slide Cover in the
Paper Load Roller Unit
7. Release the joints for the right and left slide covers and the edge guide.
8. Remove the E-ring located at left end of the paper load roller .
9. Adjust the paper load roller bushing with the cutout on the right frame.
10. Disengage the paper load gear at the right end of the paper load roller unit from the ASF
transmission gears in the middle frame. Then remove the paper load roller unit by sliding it toward
the left frame assembly.
3-28
Edge Guide Unit
Figure 3-25. Paper Eject Drive Unit Removal
Paper Eject Drive Unit
Right Slide Cover in the
Paper Load Roller Unit
Trigger Lever
Rev. A