Diagnostics Error Messages - Adaptec 5ANA-940 User Manual

Error Message
ioctl link failure
Value <value> out of
bounds

Diagnostics Error Messages

Diagnostic error messages appear at the command line when
running the aatmdiag.exe program.
Diagnostic Error Message
Error: Invalid loop
count entered. Must be
positive integer number
Error: Unable to setup
diagnostics. Check if
atmo driver is busy
SYSTEM Error: No such
file or directory File: X
Windows NT Specific Error Messages and Diagnostics
Description
An error was encountered while doing
I_PLINK or I_PUNLINK between aarp.sys ,
and atmo.sys drivers.
The value in the configuration file is out of
bounds.
Description
A negative or zero loop count is invalid for
loop
the command.
The driver is busy; several possible causes are
listed below:
Another application is using the atmo.sys
driver (another aatmdiag.exe is currently
active). Terminate the application using the
atmo.sys driver. For Classical IP, use
acipcnfg.exe . For an active ARP, use
.
net stop aarp
An invalid controller number was specified
while invoking aatmdiag -c #. Valid controller
numbers range from 0 to N, where N is equal
to the total number of physical boards in the
system minus 1. Only one adapter is
supported in a system at this time (enter 0).
The atmo.sys driver was not loaded properly.
Reconfigure the driver or reinstall the driver.
The file does not exist when using the aatmdiag
-f X option. Make sure this file exists.
B-3