Yamaha MTN850-A 2017 Service Manual page 99

1. Brake hose (front brake master cylinder to
hydraulic unit)
2. License plate light sub-lead coupler
3. Rear wheel sensor coupler
4. Brake hose (hydraulic unit to rear brake cali-
per)
5. Brake hose (rear brake master cylinder to
hydraulic unit)
6. Brake hose (hydraulic unit to front brake cali-
pers)
7. Clamp
8. Shift switch assembly
9. Wire harness
10.Rear wheel sensor lead
11.License plate light sub-lead
12.Negative battery lead coupler
13.Starter motor lead
14.Lean angle sensor
15.Gear position switch coupler 2
A. Route the shift switch lead through the inside
of the vehicle along the brake hose.
B. Secure the end of the clamp to the rounded
corners of the battery box.
C. Route the rear wheel sensor lead and license
plate light lead through the right side of the
vehicle along the brake hose.
D. Route the shift switch coupler under the
license plate light lead.
E. Clamp the protector of the brake hose and
shift switch lead.
F. The rear end of the clamp should be posi-
tioned within 10–20 mm (0.39–0.79 in).
G. Clamp the rear wheel sensor lead and
license plate light lead.
H. Place the end of the band as shown in the
illustration.
I. Leads on the front of the battery box are,
from the top of the vehicle, in the following
order: starter motor lead, stator coil assembly
lead. The orders for other leads do not mat-
ter.
2-62
CABLE ROUTING