Yamaha MTN850-A 2017 Service Manual page 93

1. Air induction system hose (air filter case to air
cut-off valve)
2. Air filter case
3. Throttle cables
4. Stator coil assembly lead
5. Boots
6. Starter motor lead
7. Clutch cable
8. Clamp
9. Front wheel sensor
10.Wire harness protector
11.Coupler cover
12.Main switch coupler 1
13.Main switch coupler 2
14.Sponge
15.Sponge edge
A. Route the air induction system hose (air filter
case to air cut-off valve) inside the throttle
cable.
B. Place the stator coil assembly lead so that
bare copper wires do not protrude from the
boots.
C. Fasten the main switch coupler to the coupler
cover with the clamp.
D. The positions for the leads on the immobilizer
unit side do not matter regarding the main
switch lead.
E. Route the front wheel sensor lead rear side of
the vehicle respect to the main switch lead.
F. Install the clamp to the hole in the bottom of
the coupler cover.
G. Make sure that the main switch coupler does
not protrude from the sponge edge.
H. Align the wire harness protector with the
edge of the Velcro tape and wrap it. However,
the tape surface may protrude somewhat.
2-56
CABLE ROUTING