10.Turn:
• Crankshaft
(several turns counterclockwise)
11.Check:
• Mark "a"
Make sure the mark "a" on the generator rotor
is aligned with the generator rotor cover mark
"b".
• Camshaft punch mark "c"
Make sure the camshaft punch mark "c" on
the camshaft is aligned with the camshaft cap
alignment mark "d".
Out of alignment Adjust.
Refer to the installation steps above.
b
a
c d
12.Measure:
• Valve clearance
Out of specification Adjust.
Refer to "ADJUSTING THE VALVE CLEAR-
ANCE" on page 3-5.
13.Install:
• Timing mark accessing bolt "1"
Timing mark accessing bolt
15 N·m (1.5 kgf·m, 11 lb·ft)
• Crankshaft end cover "2"
Crankshaft end cover
10 N·m (1.0 kgf·m, 7.2 lb·ft)
14.Install:
• Timing chain guide (top side)
• Cylinder head cover gasket "1"
• Cylinder head cover
TIP
• Apply Three Bond No.1541C® onto the mating
surfaces of the cylinder head cover and cylin-
der head cover gasket.
• After installing the cylinder head cover gasket
"1" to the cylinder head cover, cut off the "a"
section.
d
c
a
15.Install:
• Spark plugs
• Ignition coils "1"
5-17
CAMSHAFTS
1
Cylinder head cover bolt
10 N·m (1.0 kgf·m, 7.2 lb·ft)
Spark plug
13 N·m (1.3 kgf·m, 9.4 lb·ft)
2
New
1