Fault code No.
Item
6
Defective throttle position sen-
sor.
7
Malfunction in ECU.
8
Delete the fault code and check
that the engine trouble warning
light goes off.
Fault code No. P0132
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
P0122, P0123, P0222, P0223, P2135
[P0122] Throttle position sensor: ground short circuit detected.
[P0123] Throttle position sensor: open or power short circuit
detected.
[P0222] Throttle position sensor: ground short circuit detected.
[P0223] Throttle position sensor: open or power short circuit
detected.
[P2135] Throttle position sensor: output voltage deviation error.
Check throttle position sensor
signal 1.
Execute the diagnostic mode.
(Code No. 01)
When the throttle valves are
fully closed:
A value of 11–21 is indicated.
When throttle valves are fully
open:
A value of 96–106 is indicated.
Check throttle position sensor
signal 2.
Execute the diagnostic mode.
(Code No. 13)
When the throttle valves are
fully closed:
A value of 9–23 is indicated.
When the throttle valves are
fully open:
A value of 94–108 is indicated.
An indicated value is out of the
specified range Replace the
throttle position sensor.
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-157.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
P0132
O
sensor: short circuit detected (power short circuit).
2
Able to start engine
Able to drive vehicle
—
—
—
Maintenance job
8-56
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered" Go
to item 8 and finish the service.
Condition is "Detected" Go to
item 7.
Service is finished.
Confirmation of service com-
pletion