3. Remove:
• Main gallery bolt "1"
EWA12980
WARNING
The engine, muffler and engine oil are ex-
tremely hot.
4. Install:
• Pressure gauge "1"
• Oil pressure adapter H "2"
Pressure gauge
90890-03153
Pressure gauge
YU-03153
Oil pressure adapter H
90890-03139
1
5. Measure:
• Oil pressure
(at the following conditions)
Oil pressure
230.0 kPa/5000 r/min (2.30
kgf/cm²/5000 r/min, 33.4
psi/5000 r/min)
Out of specification Check.
1
2
3-26
PERIODIC MAINTENANCE
Engine oil pressure
Below specification
Above specification
6. Install:
• Main gallery bolt
Main gallery bolt
8 N·m (0.8 kgf·m, 5.8 lb·ft)
EAS30811
CHECKING THE COOLANT LEVEL
1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on a maintenance stand.
• Make sure the vehicle is upright.
2. Check:
• Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark Add the
recommended coolant to the proper level.
a
b
ECA21281
NOTICE
• Adding water instead of coolant dilutes the
antifreeze concentration of the coolant. If
water is used instead of coolant; check,
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
Possible causes
• Faulty oil pump
• Clogged oil filter
• Leaking oil passage
• Broken or damaged
oil seal
• Leaking oil passage
• Faulty oil filter
• Oil viscosity too high