Yamaha MTN850-A 2017 Service Manual page 21

temperature of the air drawn into the air filter
case.
This display shows the air intake temperature
from –9 C to 99 C in 1 C increments.
TIP
• –9 C will be displayed even if the air intake
temperature falls below –9 C.
• The air intake temperature may vary from the
ambient temperature.
Brightness control mode
1
1. Brightness level display
The brightness of the multi-function meter unit
panel can be adjusted.
To adjust the brightness
1. Turn the key to "OFF".
2. While pushing the "SELECT" button, turn the
key to "ON" and continue pushing the button
until the display switches to the brightness
control mode.
3. Push the "RESET" button to set the bright-
ness level.
4. Push the "SELECT" button to confirm the se-
lected brightness level and exit the bright-
ness control mode.
D-mode (drive mode)
D-mode is an electronically controlled engine
performance system. This model has three
mode selections: "STD", "A", and "B".
EWA18440
WARNING
Do not change the drive mode while the vehi-
cle is moving.
1. Drive mode switch "MODE"
With the throttle grip closed, push this switch to
change the drive mode in the following order:
STD  A  B  STD
TIP
• Make sure you understand each drive mode
before operating the drive mode switch.
• The current drive mode is shown in the drive
mode display, refer to "Drive mode display" on
page 1-10.
• The current drive mode is saved when the ve-
hicle is turned off.
Mode "STD"
Mode "STD" is suitable for various riding condi-
tions.
This mode allows the rider to enjoy smooth and
sporty drivability from the low-speed range to the
high-speed range.
Mode "A"
Mode "A" offers a sportier engine response in
the low- to mid-speed range compared to mode
"STD".
Mode "B"
Mode "B" offers response that is somewhat less
sharp compared to mode "STD" for riding situa-
tions that require especially sensitive throttle op-
eration.
1-12
FEATURES
1