Table of Contents
Advertisement
8.10.5
Portal connection
Select the Network tab from Settings.
By default, the storage device uses the customer's network
settings.
For this, the selection field next to Activate DHCP is checked as a
default setting.
If the connection is not made automatically, use the parameters in
the instructions for the network router. DNS and gateway address
are usually identical for commercially available DSL routers. These
addresses can differ for company networks. Moreover, ports 4500,
21 and 37 need to be enabled for the connection to the portal (does
not apply for all users).
If IP address, DNS address and gateway are to be
set up statically, knowledge of the static address
i
assignment is required.
For this, it is required to read out the router's
network configuration, for example.
The address range 172.30.xxx.xxx and
172.31.xxx.xxx must not be used as a static or
dynamic IP for the storage system.
See Chapter 9.4.2.
Subject to modification!
Updated 10/2017
99
Advertisement
Table of Contents
