Emergency Shut-Off - Bauer Rainstar TX Plus Series Operating Manual

Procedure for data input:
1. Press the following 3 keys simultaneously
seconds. The number 1 (constant no. 1) appears blinking on the display – enter the pulses per metre
according to sheet 1 or 2.
2. Press the
ON key
value.
LAYER key
3. Push the
the step described
LAYER key
4. When "b" appears on the display, push the
Thereby the machine data are saved permanently and they remain stored in the electronic system even if
the battery is replaced.
5. Checking the version number of the electronic system: Press the
ON key
WARNING!

10 EMERGENCY SHUT-OFF

Operating manual for BAUER RAINSTAR series
to increase the value, and the
to proceed to the next following constant. The data input corresponds to
above. Enter
depressed until "b" appears.
- the version number appears on the display.
The speed indicated on the tachometer applies only to innermost PE-pipe layer
(depending on the respective transmission). For 2
take the retraction speed from the diagram. The radial lines on the diagram stickers
symbolise the individual PE-pipe layers.
LAYER GEAR
GEAR key
the data up to
to save the machine data.
ON key
If something unforeseen happens you can interrupt pipe
retraction. Pull or push the gear shift lever with your open
hand from gear position I or II into the middle position. (Do
not operate the lever with your hand closed, or let it go
immediately). The gearbox is disengaged, 0 position. A
spring presses the lever up (shut-off position) and prevents
fast reversing of PE-pipe or reel.
TX Plus
ON
for
to reduce the numerical
the constant "A" or
LAYER key
first and then the
nd rd th
, 3 and 4 layer you have to
at least 3
keep the
.
53