Putting Into Operation; Steps To Be Performed Once Or As Required - Bauer Rainstar TX Plus Series Operating Manual

5 PUTTING INTO OPERATION

Before and during the first start-up grease all bearings, chains and guide parts of the winding mechanism.
normal ball bearing grease for all bearing assemblies with grease nipples, and a viscous and durable type of
grease for chains, guide rods and joints.
Tighten the wheel nuts before the first operation and check the tires for specified pressure (see Technical Data).
Tighten also the connecting bolts, the connection of the turntable side member on the undercarriage, the ball race
on the undercarriage, and the fastening of the hitch eye, according to the "Service and Maintenance" table.

5.1 STEPS TO BE PERFORMED ONCE OR AS REQUIRED

Operating manual for BAUER RAINSTAR series
65 TX Plus – 90 TX Plus with gearbox G2
Set the required track width on high-rise cart and RAINSTAR
undercarriage, depending on the existing type of crop.
Place the appropriate number of balancing weights on the
balancing pendulum of the cart.
nozzle diameters from 14 to 24 mm. For diameters larger
than 24 mm two additional weights should be placed on the
pendulum when the smallest track width setting is used.
Nozzle DIA
14 - 24 mm
from 25 mm
If the asymmetric cart design is used, the cart pendulum must
be loaded with two weights and the opposite cart wheel with
two additional weights.
Set the part circle on the wide-range sprinkler (approx. 220°
for full strip width). Confer to separate sprinkler manual for
detailed sprinkler instructions.
prevailing wind conditions by adjustment of the trajectory
angle.
TX Plus
Two weights will do for
Track 1500
2 weights
4 weights
Adjust the WINDGUN to
Use
7