Bauer Rainstar TX Plus Series Operating Manual page 54

3. Battery Check battery!
voltage 1. If the battery voltage remains low, although the solar panel is
permanently
low
4. Charging Check solar panel!
error due to

solar panel


1. There is not enough light and charging is not possible.
2. The „ + / - " phases of the solar panel are reversed. The polarity
3. The solar panel is defective. Determination by measurement at the
5. Unreadable System voltage / start-up error
1. Low voltage may be the reason for unreadable notifications on the
notifications
on the
2. This can also happen after first putting the device into operation or
display
Disconnect battery and solar panel, connect „+/-„of the ECOSTAR
cables (neutralize), after approx. 1 min. connect battery and solar panel
again. Pay attention to the polarity of the cables!
6. No length Shut-off sensor / loose PE-pipe windings
1. The PE-Rohr is completely pulled off, but the display shows 000 m.
specification
on the
a) In this case the shut-off frame on the RAINSTAR, or rather the shut-
display
b) The shut-off frame, or rather the shut-off sensor could also have
c) If the length is not counted when pulling off the pipe the value cannot
PE-pipe length specification at the ECOSTAR
Proceed as follows (see also operating manual)
a) Set retraction speed to 11,1 m/h
b) Press the key PROGRAM 3x, this way parameter sheet no.1 shows,
Operating manual for BAUER RAINSTAR
charging, check battery, charge battery or exchange it.
Notes !
The normal charging function of the solar panel works as follows:
when the battery voltage is 14,0 V or more the charging function
switches off. On the display of the first menu window the sign „OFF"
appears when „charging with solar panel" (1x MENU key)
If the battery voltage is 13,9 V or less, the charging function switches
on and on the display appears „ON" in the same menu window.
If the solar panel does not charge the battery although the voltage is
13,9 V or less, on the display „OFF", the reasons are as follows:
should be measured.
exit of the panel.
display .
after connecting the battery again (even if sufficient voltage is
available)
Note !
Notes !
off sensor was activated and the pipe length display switches to 000
m and the ECOSTAR stops the operation of the RAINSTAR.
The shut-off frame could also have been activated manually due to a
loose PE-pipe- winding.
been activated while pulling down the PE-pipe. In this case the length
of the laid down pipe is shown, the shown value, however, is smaller
than the actual length of the pulled off pipe. The value must be
entered again as described below.
be corrected and the RAINSTAR does not start. In this case the
shut-off sensor is not adjusted correctly (distance too short, see
operating manual)
by pressing the key PROGRAM again you get to constant 7.
Series TX Plus
Check
battery/charge or
exchange.
Correct polarity
Change panel
Check battery
voltage , charge
battery
Bring electronics
in voltage-free
state for approx.
1min.
Set PE Pipe-
Length on the
ECOSTAR again
46