Operation; Opening - Simons Voss Technologies PinCode Keypad Manual

PinCode Keypad

2.3 Operation

(Manual)
Status
Standby

Opening

Programming
Battery warning
IMPORTANT
Locked programming with low battery
If the battery warning is active, you cannot change the programming of the
PIN code keypad. You cannot change or delete any User PIN.
1. Replace the batteries (see
2. Perform the desired change.
Once you have put the PIN code keypad into operation and programmed it,
the PIN code keypad, together with a SimonsVoss locking device, forms a
so-called "mental lock" in System 3060.
You programme the PINs directly on the PIN code keypad, while you
programme the integrated transponders with the LSM software and thus
integrate them into the System 3060.
Explanation
Sleep mode. The PIN code keypad
consumes very little energy.
Active mode. The PIN code keypad
checks the input and, if the input is
correct, actuates the locking device
via radio (see
Operation [ 6]
}
PIN programming: The individual
PINs (max. three) are programmed/
reset directly via the keyboard (see
PIN programming).
PINs [ 10] ).
}
Transponder programming: The as-
sociated integrated transponders
(max. three) are programmed/reset
via the LSM software (see
ming the transponders [
Low battery. A two-stage battery
warning system signals you in good
time when you need to change the
battery (see Signal [
tery replacement [
Battery replacement [
2. How it works
6 / 28
How it works [ 5] and
}
).
Programming
Program-
13] ).
}
18] und Bat-
}
20]
).
}
20] ).
}