Programming Pins - Simons Voss Technologies PinCode Keypad Manual

PinCode Keypad

4.2 Programming PINs

(Manual)
2. Enter the old Master PIN (factory setting: 12345678).
3. Enter the new Master PIN.
IMPORTANT
Requirements for the Master PIN
The Master PIN must be secure. It must therefore meet the following re-
quirements.
1. The Master PIN must consist of eight characters.
2. The digits of the Master PIN must not be consecutive.
3. The Master PIN must not begin with 0.
4. Enter the new Master PIN again.
9 PIN code keypad beeps and flashes green twice.
Master PIN is changed.
9
Enter 0000
Enter the old master PIN
Enter the new master PIN
Enter the new master PIN
(repeat)
You can programme up to three User PINs in the PIN code keypad.
Each User PIN behaves like its own transponder. The individual User PINs
must therefore be programmed separately in the respective transponders.
If you do not want to use all User PINss, leave them unprogrammed.
1. Enter the number sequence 0.
2. Enter the Master PIN.
3. Enter the number of the User PIN (for example, 1 for User PIN no. 1).
4. Specify the number that determines the length of the User PIN (for
example, 4 for a four-digit User PIN).
5. Enter the new User PIN.
4. PINs
10 / 28