Reading Out The Transponders - Simons Voss Technologies PinCode Keypad Manual

PinCode Keypad

5.2 Reading out the transponders

(Manual)
9 "Programming successful" window is displayed.
User PIN was linked to the entry in the matrix.
9
Repeat the programming for all other User PINs that you want to assign.
If you do not want to use all User PINss, leave them unprogrammed.
Set up transponder
(LSM software: "G1 PinCode")
Open the programming menu
(LSM software: "Programme")
Enter 00
Enter the master PIN
Start programming
(LSM software: "Programme")
Enter 1,2 or 3
(Number of the transponder)
You can read out the integrated transponders.
1. Click the button Read transponder
9 The window "Programming" opens.
2. Enter the User PIN whose transponder you want to read out.
IMPORTANT
Radio error
If you hold the transponder too close to the programming device or activ-
ate the transponder too early, the radio link cannot be established.
1. Keep a distance of about 20 cm!
2. Do not activate the transponder until you are prompted in the LSM
software to press the transponder button.
9 The transponder is read out.
PIN code keypad beeps and flashes green twice.
9
5. Transponder
.
15 / 28