A Quick Method Of Learning A Transmitter Button Code - E.T. Systems DC BLUE ADVANCED Installer's Instructions

A QUICK METHOD OF LEARNING A TRANSMITTER BUTTON CODE INTO THE RECEIVER MEMORY WITHOUT
NB!! No remote codes can be learnt into the (LT) courtesy light channel this way.
Door must be closed
Press and hold the "Up"
button until buzzer beeps
and display shows "b".
Press and hold required
remote button.
Press and release the
"SET" button.
Release both the remote
button and "SET" button
ET DC BLUE ADVANCED INSTALLER 2012.025.12.05.2014
ENTERING THE PROGRAMMING MENU.
Max users (BT) button trigger channel = 35 user codes
Action
Door closed
Buzzer beeps once and
display shows "b"
LED on remote
transmitter remains lit.
"1" on display and 1
beep = user code
successfully registered.
"2" on display and 2
beeps = user code
already in the receiver
memory.
"3" on display and 3
beeps = Unsuccessful
because no code was
seen within 4 sec of the
"SET" button being
pressed.
Mandatory timeout.
"F" on display and
multiple rapid beeps =
Memory full
Display reverts back
standby mode "II"
22
www.et.co.za
Response
Successful
Code already in
memory
Unsuccessful
Memory full